Rubber Mats For Electrical Purposes
Application
Rubber mats are used as floor covering around electrical panels with rated voltage
of 3300 working as as safeguard to the life and limb of the workman due to possible
leakage of current and short circuit.
Rubber mats are used in power generation plants, sub-stations, workshops etc.
| Constructions | |
| Composition | Manufactured Out of Rubber Compound Of high quality Natural rubber |
| Surface | The rubber mats have chequered, anti-skid fluted design or plain on one side and plain at bottom as per the requirement of the purchaser. |
| Size | Thickness 6.5mm to 25mm Width/Length 0.9 to 1.8 meter. |
| Colour | Black/ Grey or Red as per your requirements |
| Technical Particulars | Tensile Strength 50 Kgf/cm Elongation at break 250% |
| Voltage Test | The rubber mats are tested to pass the voltage test at 15000 volts for one minute |
| Breakdown Strength | Shall not fail at less than 40000 volts as per procedure outlined in IS-2584/83 |
|
Copyright 2001 Kan-Vick Industries. All Rights Reserved |
|
Website Developed and maintained by Rose Web Creations - Providing Solutions Beyond The Obvious |